Home > Knowledge > Content

What is the precautions while using the solar panel laminator

Mar 30, 2025

When using the machine, please conform to the following precautions:
1. Turn off the main power supply
In order to prevent the machines associated with the laminator from interacting with each other, the main power supply shall be turned off after the laminator operation is complete.
2. Turn off the hot oil pump
The solar panel laminator is heated by oil. When heating, the hot oil pump must be turned on first. While the pressure gauge shows that the oil pressure is between 0.2 and 0.5 MPa, and then the heating switch can be turned on. When turning off the machine, the heating power is turned off first, after the temperature is lowered and the oil was circulating for 30 minutes, then turn off the hot oil pump.
3. Grounding
To prevent malfunctions caused by electric shock and static electricity, ensure that the power grounding terminal of the machine is connected to the ground. (Grounding)
4. Prohibit to use in hazardous locations
Please do not use this machine in places with flammable gases or flammable vapors. For the usage under such conditions, please contact us.
5. Power supply
The power supply voltage range is: AC380 ~ 400V, 50HZ. When using in a place with poor power supply, we recommend using protective measures such as a stabilized power supply. Pay attention to check the motor steering during the initial power-on to prevent the reverse rotating from damaging the machine.
The machine works normally in the temperature range of 10 °C ~ 40 °C, and can be stored in the temperature range of -40 °C ~ 80 °C, but avoid long-term storage at high temperature.
6. Operational safety
6.1.To ensure good operation of the device, please do not place anything on the laminated frame.
6.2.Before opening the cover, please check whether the lower chamber inflation is completed, otherwise it is not allowed to open the cover to avoid damage to the machine.
6.3.The machine has an emergency button. When pressed in an emergency, the whole machine will be powered off (do not press it while the machine is running normally, otherwise it will stop all the ongoing programs). After troubleshooting, can rotate in the direction of the arrow on the button to reset.
6.4.If the machine has not been used for a period of time, it should be operated for three empty cycles after being turned on, so as to drain the residual gas and water vapor adsorbed in the chamber to ensure the quality of the lamination.
6.5.Be sure to power off for maintenance or doing relative tests in Manual Mode to prevent damage to the machine or injury to the operator.

If you want to know more information about our company or products, please feel free to contact us.

Contact now

Send Inquiry