The laminator should also operate correctly in terms of operating procedures. It has certain processes:
1. You need to press the vacuum pump button to view the process parameters.
2. Check the temperature value, vacuum pump, working status, etc., such as whether the temperature reaches the set value, whether the vacuum pump is short of oil, whether the working status is automatic or manual, generally set the automatic status.
3. Put the components to be laminated and close the cover. The operator checks the vacuum degree and then takes out the components.
In the case of ensuring that all processes are normal, the laminator enters the working state. Shutdown also has a certain process:
1. It is required to turn off all power supplies. In order to ensure that it is not operated by mistake, the emergency button can be included in the shutdown range.
2. Close the vacuum pump cover, and turn off the heating switch and power switch.
After the laminator has been parked for a period of time, do not put in the battery board. First run the machine empty for two cycles, and clean the water vapor absorbed in the machine before it can be used normally.
