Photovoltaic module processing is an important part of the solar photovoltaic industry chain, by packaging a thin piece of solar cells, so that it can operate reliably in harsh outdoor environments.
The first step is solar cell inspection. As the main raw material of photovoltaic module processing - the performance of the solar cell directly determines the quality of the photovoltaic module, therefore, in addition to its appearance, color difference and resistivity detection, but also to test the solar cell in the specific light, temperature conditions of the output current, output voltage and stability and durability and other parameters, its test is mainly completed by professional instruments and equipment.
The second step is single-piece welding of the solar cell. The welding should be firm, no burr, no virtual welding and tin slag, and the surface is smooth and beautiful.
The third step is serial welding of the solar cell. During welding, the solder bar is required to be welded flat, with a straight appearance, no raised solder bumps, and no virtual welding phenomenon.
The fourth step is stacking. Lift the tempered glass to the laminated work table, the suede side of the tempered glass faces up, and lay a layer of EVA on the tempered glass. EVA on the four sides of the tempered glass margin ≥5mm. After stacking, the EL test should be carried out to confirm that there are no hidden cracks, virtual welding, welding, black film and other defects.
The fifth step is lamination. Start the laminating machine according to the operation procedure of the laminating machine equipment, adjust the laminating temperature and evacuation time according to the EVA characteristics, record the temperature, pressure and other technical parameters on the operation record sheet. When the laminating is finished, the laminating machine automatically opens the cover and takes out the processed component in time. It is required that the chip in the component has no foreign matter, debris, cracks, etc.
The sixth step is framing. Evenly fill the aluminum alloy frame groove with silicone, insert the component into the aluminum alloy groove, and start the framing machine to complete the framing. At the junction of TPT and aluminum alloy on the back of the component, evenly apply silicone gel to the back of the junction box of the corresponding specifications and the root of the lead wire, and glue the junction box to the lead wire.
The seventh step is cleaning. Tear off the plastic film on the surface of the aluminum profile, and clean various pollutants on the surface of the component with wine semen to ensure that the appearance of the component is clean and pollution-free.
The eighth step is the testing of finished components. According to the operating procedures of the solar module tester, the electrical performance parameters of the module are calculated and recorded.







